Kun muutat ton asetuksen 70/30, niin nopeudensäätimelle pitää opettaa missä on uusi kaasun nollakohta. Tuoshan ei oo muuta ideaa, kuin että se tuo lisää liikerataa kaasuun ja sitä kautta herkkyyttä. Manuaali kertoo seuraavaa:
Page 14:
You will need to reprogram your electronic speed control
to recognize the 70/30 setting. Turn to ESC Setup Programming on
page 17 for instructions.
Page 17:
Setup Programming (Calibrating your ESC and transmitter)
Read through all of the following programming steps before you
begin. If you get lost during programming or receive unexpected
results, simply unplug the battery, wait a few seconds, plug the battery
back in, and start over.
1. Disconnect each of the motor wires between the ESC and the
motor. This is a precaution to prevent runaway when the speed
control is turned on before it is programmed.
2. Connect a fully charged battery pack to the ESC.
3. Turn on the transmitter (with the throttle at neutral).
4. Press and hold the EZ-Set button (A). The LED
will first turn green and then red. Release the
EZ-Set button.
5. When the LED blinks RED ONCE.
Pull the throttle trigger to the
full throttle position and hold it
there (B).
6. When the LED blinks RED TWICE.
Push the throttle trigger to the
full reverse and hold it there (C
7. When the LED starts flashing GREEN,
programming is complete. After the throttle is
returned to neutral, the LED will then shine solid
green or red (depending on the Low-Voltage
Detection setting, see note below) indicating the
VXL-3m is on and at neutral (D).