Eli jos ei ennestään ole AMB:n ponderia, ei kannata tuota halvempaa ponderia ostaa?
Kakspiippunen juttu.
Mikäli näitä pondereita halutaan kloonaamattomana eli vain samoilla 20 numerolla ja halukkaita on paljon niin tämä saattaa aiheuttaa ongelmia kisoissa.
Mikäli suurin osa haluaa kloonata oman jo olemassa olevan ponderin niin ongelmia ei pitäisi tulla päällekkäisen ponderinumeron kanssa.
Itse esim ajattelin ottaa 2 kloonattua yhdestä nykyisestä, jolloin eri luokan autoissa on sama ponderinumero... Helpottaa numeron muistamista kisoihin ilmoittautuessa.
Ps: mites muuten kyseisessä ponderissa tietää mikä on milloinkin käytössä???
Jos siis vaihtaa ponderi numeroa niin mistä tietää mikä numero siellä on sitten käytössä???
How to change the ID Number: with PIX connected (LED is on) press and hold
the setup button until the LED flashes. .The number of flashes displays the ID that
is set (also press and hold the setup button to switch between number SET 1 & 2).
With the LED flashing in 'setup' mode.to'chanqe the ID number press and release
setup button until the required ID is selected (ID 1-10 "flash" or 1-10 "flicker-flash'1
then disconnect PTX from power to corhplete the ID number selection.
Custom / Cloned ID Number selection: sets custom/cloned number (if available)
press and hold the setup button and then connect the PTX, the LED will display a
"constant flicker-flash", disconnect PTX to complete selection of custom/cloned ID.
*To select new custom ID (if available) follow instructions for selection as described
and then continue to hold. After 'warningreset flashes' custom ID is set to a new ID.
ID Number Display: to show the currently selected ID number, press and release
the setup button when the PTX is connected to power and is not in 'setup' mode.
(Note: pass PTX over AMBrc / AMBrc3 loop to display new custom 10 after 'ID reset')