Tässä originaalissa muodossa ja ydinkohta lihavoituna.
Tank 1
1. Drive the model with the body off.
2. Driving procedure: Gently pull the throttle trigger to 1/4 throttle over
a 2-second count. Then gently apply the brake to stop. Count the two
seconds out while accelerating: one thousand one, one thousand two,
and then stop. Operate the throttle trigger as smoothly as you can.
Repeat this starting and stopping procedure until the first tank of
fuel is nearly empty.
3. Look for thick blue smoke exiting the exhaust outlet. If there is
no smoke, richen the high-speed needle 1/4 turn, by turning the needle
counterclockwise.
4. When the fuel tank is nearly empty, shut off the engine by pinching the
fuel line connected to the carburetor (use the installed clamp).
5. Let the engine cool for 15 minutes.
Note: If at any point the engine cuts out or stalls during gentle
acceleration, richen the high-speed needle 1/4 turn by turning the needle
counterclockwise.
Tank 2
1. From tank 2 forward, Revo should be driven with the body on.
2. Driving procedure: Gently pull the throttle trigger to 1/2 throttle over
a 2-second count. Then gently apply the brake to stop. Count the two
seconds out while accelerating: one thousand one, one thousand two,
and then stop. Repeat this starting and stopping procedure until the
second tank of fuel is nearly empty.
3. When the fuel tank is nearly empty, shut off the engine and let it cool
for 15 minutes.
Tank 3
1. Driving procedure: Gently pull the throttle trigger to 1/2 throttle over
a 3-second count. Then gently apply the brake to stop. Count the
three seconds out while accelerating: one thousand one, one thousand
two, one thousand three, and then stop. Repeat this starting and
stopping procedure until the third tank of fuel is nearly empty.
2. As the engine loosens, the idle speed may increase and cause
the model to try to creep forward when stopped. Reduce the
idle speed by turning the idle adjustment (see page 19) on the
carburetor counterclockwise.
3. When the fuel tank is nearly empty, shut off the engine and refuel.
From here on, you do not need to let the engine cool between tanks.
Tank 4
1. Driving procedure: Gently pull the throttle trigger to full throttle over
a 3-second count. Then gently apply the brake to stop. Count the
three seconds out while accelerating: one thousand one, one thousand
two, one thousand three, and then stop. Repeat this starting and
stopping procedure until the fourth tank of fuel is nearly empty.
2. Apply the throttle gradually! Your finger should not reach full throttle
until the end of the three-second count. Revo may try to shift into
second gear. If it does, reduce the throttle input. Do not let Revo shift
out of first gear.
3. Keep your driving smooth and consistent.
4. When the fuel tank is nearly empty, shut off the engine and refuel.
Tank 5
1. Driving procedure: Gently pull the throttle trigger to full throttle over
a 3-second count, hold for 2 more seconds, and then gently apply
the brake to stop. Count the five seconds out while accelerating.
Repeat this starting and stopping procedure until the fifth tank of
fuel is nearly empty.
2. The model should now be shifting into second gear. If it is not, try
turning the high-speed needle clockwise 1/8 turn to lean the fuel
mixture slightly and test for shifting.
3. When the fuel tank is nearly empty, shut off the engine and refuel.
Tank 6
STOP! Clean your air filter before you proceed. Refer to the instructions
on page 23. During the sixth tank of fuel, the engine can be tuned
for general performance use. Proceed to the next section in this manual.