Engine
Model DuraTrax Break-in Settings
High Needle Low Needle Idle
TORQ .12 2 3/4 turns from fully closed 1mm gap between the idle needle and the spray bar barrel open 1.5mm
Velocity .15 2-1/2 turns Needle flush with the outside edge of carburetor body barrel open 1.5mm
TORQ .16 2 3/4 turns from fully closed 1mm gap between the idle needle and the spray bar or approx. 2-3/4 to 3 turns out barrel open 1.5mm
DuraTrax After Break-in
TORQ .12 3/4 to 1 1/4 turns from fully closed 1mm gap between the idle needle and the spray bar barrel open 1.5mm
Velocity .15 approx. 1 3/4 turns from fully closed Needle flush with the outside edge of carburetor body barrel open 1.5mm
TORQ .16 3/4 to 1 1/4 turns from fully closed 1mm gap between the idle needle and the spray bar or approx. 2-3/4 to 3 turns out barrel open 1.5mm
Note: Final settings of the high speed needles shown are guidelines only. Final settings should be done buy taking the temperature of the motor after it has warmed up. This should be approx 250 degrees or apply a couple water drops to the top of the head and the water should boil away in 5 seconds.
Edit: Miten tuo muuten voi olla noin vähällä määrällä?... Pyöreä kierros? Kun se on nyt ollut noin 3 kierrosta ja tuntuu että paistuu? :shock:
Vähän selkeämmin nuo setupit...
http://www.hobbytalk.com/modules.php?op=modload&name=News&file=article&sid=49